[dss-developer] Event Acknowledge

[Meier Dominik]

Dear all,

I have a very short question about the digitalSTROM protocol, I know, this is a bit closer to hardware than software but probably you can help:

When I release an event with the dSS, is there any confirmation or acknowledgment that the event has been processed by a dSID or not?
Do I have to care about it or is this service provided by the communication protocol between dSM's and dSID? What happens if an event does not reach an end device? Is there any Layer 4 (end to end error control) functionality provided in the protocol?

I just want to be sure that a device turns definitively on or off if I release an event :-)

Thanks for your help!
Regards
Dom



------------------------------------------
Fachhochschule Nordwestschweiz
Hochschule fuer Technik
Institut fuer Aerosol und Sensortechnologie

Meier Dominik
Klosterzelgstrasse 2
5210 Windisch Switzerland
-------------------------------------------
T: +41 56 462 42 92
N: +41 79 679 46 84
F: +41 56 462 47 11
dominik.meier at fhnw.ch
http://www.fhnw.ch/technik/iast

IMPORTANT:
The information contained in this e-mail and any attachments is confidential to FHNW and must not be passed to any third party without permission. This communication is for information only and shall not create or change any contractual relationship.