[dss-developer] Interpreting device parameters

[Dimitri Janssens]

I work at One Smart Control.

Our user interface needs to know what configuration a device is in and
show this in our user interface.
A user also needs to be able to change this configuration.

Example: change output from switched to dimmable.

Is it possible to get an overview of these magic numbers then?

Best Regards
-- 
ing. Dimitri Janssens
software engineer
___________________________________________________________

Sioux. Source of your Technology
Technical Software | Electronics | Industrial Mathematics | Remote
Solutions
 
Sioux Embedded Systems N.V. |  Welvaartstraat 14-1 bus 5 |  B-2200
Herentals |  Franklin Rooseveltlaan 348-349 | B-9000 Gent | Belgium
BE 0470.946.282 - RPR Turnhout | T +32 (0)14 84.87.18 |  F  +32 (0)14
84.87.19 |  dimitri.janssens at sioux.eu |  www.sioux.eu
<http://www.sioux.eu/>





On 16/08/13 11:47, "Hofmann, Christoph" <christoph.hofmann at aizo.com> wrote:

>Dear Dimitri,
>
>> I'm am at a point where I need to interpret device parameters.
>
>why do you need to interpret these parameters? They are just used
>internally.
>
>
>> 35 = no outputs available?
>
>35 means relay output, used by GE-KL200.
>
>
>> Is there a logic for these values?
>
>No, there is no logic. We are using magic numbers for output modes.
>
>
>Best regards
>Christoph
>
>
>--
>Christoph Hofmann
>Softwareentwicklung
>aizo gmbh
>
>
>