[dss-developer] Interpreting device parameters

[Hofmann, Christoph]

Dear Dimitri,

> I work at One Smart Control.

aaah, ok.

We should not discuss these internal things in our open source community developer group.
Please write down your questions and submit these through your project owner (David Vanstraelen?) to us. You will get your answers ;-)

Best regards
Christoph


--
Christoph Hofmann
Softwareentwicklung
aizo gmbh



> -----Ursprüngliche Nachricht-----
> Von: dss-developer-bounces at forum.digitalstrom.org [mailto:dss-
> developer-bounces at forum.digitalstrom.org] Im Auftrag von Dimitri Janssens
> Gesendet: Freitag, 16. August 2013 12:14
> An: dSS development list
> Betreff: Re: [dss-developer] Interpreting device parameters
> 
> I work at One Smart Control.
> 
> Our user interface needs to know what configuration a device is in and
> show this in our user interface.
> A user also needs to be able to change this configuration.
> 
> Example: change output from switched to dimmable.
> 
> Is it possible to get an overview of these magic numbers then?
> 
> Best Regards
> --
> ing. Dimitri Janssens
> software engineer
> __________________________________________________________
> _
> 
> Sioux. Source of your Technology
> Technical Software | Electronics | Industrial Mathematics | Remote
> Solutions
> 
> Sioux Embedded Systems N.V. |  Welvaartstraat 14-1 bus 5 |  B-2200
> Herentals |  Franklin Rooseveltlaan 348-349 | B-9000 Gent | Belgium
> BE 0470.946.282 - RPR Turnhout | T +32 (0)14 84.87.18 |  F  +32 (0)14
> 84.87.19 |  dimitri.janssens at sioux.eu |  www.sioux.eu
> <http://www.sioux.eu/>
> 
> 
> 
> 
> 
> On 16/08/13 11:47, "Hofmann, Christoph" <christoph.hofmann at aizo.com>
> wrote:
> 
> >Dear Dimitri,
> >
> >> I'm am at a point where I need to interpret device parameters.
> >
> >why do you need to interpret these parameters? They are just used
> >internally.
> >
> >
> >> 35 = no outputs available?
> >
> >35 means relay output, used by GE-KL200.
> >
> >
> >> Is there a logic for these values?
> >
> >No, there is no logic. We are using magic numbers for output modes.
> >
> >
> >Best regards
> >Christoph
> >
> >
> >--
> >Christoph Hofmann
> >Softwareentwicklung
> >aizo gmbh
> >
> >
> >
> 
> _______________________________________________
> dss-developer mailing list
> dss-developer at forum.digitalstrom.org
> http://forum.digitalstrom.org/cgi-bin/mailman/listinfo/dss-developer